Yes! You are right, I do not have a wireless card on the router (RB450G) because the Access Point will be a separate device (cAP) connected to eth2 on the RG450G. The hotspot is configured on the router board only.Hi Boris,
"no such item" means that something is missing on the routerboard you are trying to configure.
For example, you enabled the "Use Wireless" field in the HSNM gateway configuration but your routerboard doesn't have wifi.
Be also sure to be using at least RouterOS 6.37, as suggested by the pop-up message shown when you download gateway configuration files from HSNM.
Hello again, sorry but can you advise us on the configuration through the custom commands for the scheme? Can you give us some example based on the picture I sent?Hi Boris,
I saw your schema.
To be able to use eth3 and eth4 as you would like you have to add all the configuration through the custom commands you can set on the HSNM gateway configuration. Then you have to download again configuration files and import them again.
Users browsing this forum: No registered users and 2 guests